Could someone point me to the vector rescanning patch diagram that was on the site earlier this year? Thanks

These? [1136_1060_xyz_scope_sigs_1_1%20(1)] [1136_2032_ruttetra_1_1%20(1)]

Interesting, but I’m looking for documentation Lars released using Navigator, Shapechanger, Bridge, Passage, etc. Was it removed from the site?

That’s the one, thanks @destroythings

i’ve tried (for months) to get this to work. i get vectory shapes but i can’t get anywhere near what the camera is seeing. playing with the modules changes things but so does playing with the oscilloscope. i’ve tried to set the modules as per the diagram and instructions, if anyone has time, please…

Can you post any video of what you’re seeing and a patch diagram? There’s not any informaton on the Z axis input on the manual you posted there but I found another one where it states on section 1.2.13 that the Z axis is either off at 0V or +5V (or not connected) is on. Since this doesn’t explicit…

LZX Community

Vector Rescanning workflow?

Helpdesk

destroythings September 22, 2018, 9:02pm 4

A patch for Rutt-Etra style scan processing with an XY display Patching

[rescan%20patch] Modules: Visual Cortex, Navigator, Bridge, Passage, Shapechanger Additional Equipment needed: Monochrome CCTV Camera XY Display XY Signal Flow Navigator and Shapechanger are used to process H & V ramps before they are sent to the XY display. This allows control over XY position, rotation, width, height, curve, and skew of the resulting vector image. Patch Visual Cortex - Ramp Generator - Vertical Ramp Out to Navigator - IO - Vertical In Patch Visual Cortex - Ramp Gene…

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled