I recently acquired a sizable case that I am ditching 2 smaller and upgrading to one case with room to grow. I will end up needing to install 4 Malekko Power’s. I am a total noob with how to do this but can follow directions and solder. Some mentioned running 2 board to each brick but i have no idea…

Okay, the confusion continues. Hope this helps more clueless folks than just me. From Perfect Circuit today: ‘Thank you for reaching out to us. All the current stock that we have is hardware v. 1.3. We are expecting a batch of the updated units soon…’ This is confusing, though. Is version 1.3 the …

V1.3 is the current version. I heard from DP yesterday that they are building more this week.

Better than the response I got which was that the ‘firmware’ was 1.3 :), the units Perfect Circuit has in stock are the 1.3 version which I only implied with my initial response.

Just got mine today! And, yes the 1.3 as you said @wiatrob . Along with my Escher Sketch, after repairs and a long weird journey in the hands of the postal service. Thanks so much for everyone’s help!

So, I have installed 2 Malekko power busses in my new case. I am going to wire them with jumpers for cv and gate, from one buss to the other. Should I also install jumpers from zone to zone, within each buss because the zones are isolated from each other? …Is lzx selling the jumper cables any more? …

Like you, I have 2 Malekko PSUs. I linked them with a single bridge cable and everything works fine. PRs in 2 zones, no other links needed. Just make sure you connect the cable to the right pins!

Also installing 2x Malekko this weekend. I was able to fit all my bus-sync-only modules in one of the cases, so I can do RCA sync for the second case. My understanding is that you don’t need to jumper across the zones; the zones’ CV and gate lines are connected. This is not really a Malekko-specif…

I’m using the tta dual access module for power entry. This has switchs for both power bricks, so I can turn off the power to the modules in that entire cabinet when I’m not using them. I can also independantly power the top or the bottom PSUs for when I only need half the synth. However, the core mo…

Got the rig powered up and some basic test patches run. Malekko is happy, mods are happy, images are super-clean! Thanks for the help. Yes, I installed a switched hospital grade power entry with fuzes and filters…taking no chances…

that sounds useful where did you find that?

MALEKKO POWER Help/Advice

Helpdesk

Dewb January 8, 2020, 5:55pm 37

https://community.lzxindustries.net/uploads/default/original/2X/c/cce0bfaec3f39257e997ec5eba8dc9488808619d.png